2/23/14

XT500 MX project

I'm getting started on another XT500 project, this one will be a motocrosser. Here is the bike when I bought it back in '09.
100_1722

Here it is stripped down and ready to begin.
100_5649

The tank I'll use is from a '76 YZ125. It'll need a fair amount of tunnel work to fit the XT500 frame.
100_5661

The swingarm is from a '77 Suzuki RM250.
100_5654

The RM swingarm is 3" longer from pivot to axle, and 1" shorter from pivot to shock mounts.
100_5663

The first thing will be to fit the swingarm, doing a test fit here. It has a smaller diameter pivot bolt, and is also a bit narrower at the pivot, but shouldn't be too difficult to adapt.
100_5666

2/16/14

DT1 flat track project

During mock-up I'd slid the forks up in the trees about 1.5" to get the bike to sit right, so I wanted to internally lower them. These forks use a long spacer at the top, so I cut a 1.5" and 2" spacer from 1/2" pvc. The shorter one goes on the damper tube, and the longer one on top where the old one was. Normally you'd get new aftermarket springs, or at least use a longer top spacer to increase preload, but during mock-up the sag felt about right, and since the TX650 the forks are from is about twice the weight of the DT, the old springs might be alright. If not, it is an easy swap later on.
100_5625

This spacer pulls the fork tubes 1.5" lower into the legs at full extension, which lowers the total length.
100_5628

Later Yamaha forks use a 17mm hex key to hold the damper tube from turning when tightening or loosening the bottom damper bolt, but for the early forks you can use a 12mm 6 point socket with 4 sides ground off.
100_5635

I'm using All Balls fork seals, but got genuine Yamaha dust boots from boats.net for about $30 for the pair.
100_5620

Here they are ready to go.
100_5641

2/9/14

TX750




source: http://auctions.search.yahoo.co.jp/search?p=tx&auccat=26316

DT1 flat track project

The '73 TX650 forks I'm using have lots of tabs that need trimmed off since I don't need any of them for this bike.
101_5462

I removed them using an angle grinder with a cut-off wheel.
100_5562

The fork lower after the trimming.
100_5563

Next was to smooth out the cuts. I started with a flapper wheel, then finished with a fine metal file. The important thing here is to avoid any scratches that will take more time to polish out later on.
100_5567

Then was wet sanding with soapy water first with 400 grit, then going to 1000 grit, and then some Autosol metal polish.
100_5611

2/2/14

DT1 flat track project

I trued the rims and spooned on the tires. Once the forks are done I should be ready to start final assembly later this month.
100_5588

100_5585

100_5579

100_5583