10/25/14

DT1 MX project

For the '69 DT1 I'm going to freshen up a set of Boge Mulholland shocks. These were $60 'buy it now' on ebay, and in very nice shape. Rebuilding a set of old aftermarket shocks is a good way to go on a budget project. You can save money, and have a some neat period parts at the same time. Make sure the shafts aren't rusty or worn, since new replacements wouldn't be easy or cheap to get.
100_9954

These are the MX1350 model shocks. The Junk Man's Adventures has some great information on these here: http://www.thejunkmanadv.com/boge-mulholland-shocks-info.html The MX1350 takes 110 cc of oil.
100_9955

First thing is to remove the springs. I use these spring compressors. They are inexpensive and easy to use.
100_9958

The springs were in fairly good shape. I just scrubbed them up and gave them a thin mist coat of paint. I used the same Dupli-Color black as the frame.
101_0007

Now to the shock body. I first held the top eyelet in a vise and loosened the lock nut. I then slit some old air hose and put it over the shaft so I could hold it in a vise to unscrew the eyelet.
100_9962

Here it is apart.
100_9965

Now to remove the seal nut. This is the housing for the seal, and holds the shock internals in.
100_9967

These look like they are just pot metal, and are known to break, so only use the correct 6 point socket and go slow and easy on them. I held the bottom eyelet in a vise to loosen them.
100_9971

After the seal nut is off, remove the O-ring and pull out the internals.
101_0086

Here are the internal parts.
101_0090

I then screwed the seal nuts back into the empty shock body to hold them so I could knock out the old seals. I bought some 11 x 25 x 7 mm double lip seals, and pressed them in.
101_0092

Here are the parts cleaned up, and the new seal in the seal nut.
101_0108

These shocks had been painted red a some point. Peeling back the label you can see the original orange.
100_9998

I sandblasted them, and then used Dupli-Color self etching primer and Chrysler Hemi orange engine paint. I think Chevy orange might have been closer to the original color, but I like the Hemi orange.
101_0112

Here they are painted and ready to reassemble.
101_0102

For oil I'm using Castrol Transmax synthetic ATF.
101_0111

Here they are reassembled other than the springs.
101_0119

Here the springs are back on. They look great out in the sunlight.
101_0130

I installed new needle bearings in the swingarm, and put it and the shocks on the frame.
101_0145

101_0147

10 comments:

OldMotoDude said...

Nice "How to". Where did you get your spring compressors?

Joe C said...

Thanks! I bought the spring compressors on ebay. They do work nicely.

TheJunkMan said...

Nice article! And thanks for linking my site with the Mulholland info. I returned the favor by linking to this post on my page for those wanting to see a pictorial breakdown. I had forgotten to take pictures during my rebuild. You did a good job.

Joe C said...

Jon, posting that rebuild info was very helpful, so a big thank you!

jim dinky5002@verizon,net said...

does anyone have top seal nuts. need two

ivebeenrobbed said...

Are those Boge Mulholland springs? The springs seem to be harder to locate than the shocks, curious if the Progressive Series 12 will fit. May have to attempt and see. Great job on the restoration and thanks for sharing!

Unknown said...

Albert N :
The seals. It appears the original seal is a much smaller and flimsier seal than the double lip seals you replaced with. Am I reading that right about the seals? Any tricks about the seal replacement as you did? Thanks! This is an awesome blog!!!

AHRMA Mike said...

I am currently reproducing seal heads for these shocks if anyone needs them.twowhlman@verizon.net Thanks, Mike Ruggiere

LarryG said...

Hello, where did you get the plastic covers for these guys? Great write up, appreciate it.

Unknown said...

If you're too cheap and broke to buy spring compressors then use thick zap straps. They work fine too.
I have the SS13310's. I have 3 of them so if anyone wants to sell me one let me know :)

thebetterlife@hotmail.com